Adel BCR Bedienungsanleitung PDF herunterladen (Seite 7)

ADEL S.r.l. – BCR Barcode / Contactless reader - User Manual Rev. 1.3

pag. 7

5.1.4 I/O SIGNAL CONNECTOR

Besides the I/O signals present on the I/O 1 connector, on the I/O 2 connector an input digital signal and a

power output signal are available and ideal to drive a ralay.

The I/O 2 (JST PH 4x1 PM 90°) connector pinout is the following:

Pin 1 OUT 3B

Pin 2 GNDPP

Pin 3 IN 3B

Pin 4 GND

5.1.5 OPTO #3 CONNECTOR

On the OPTO #3 connector the connection for a optional external optical sensor is available.

The OPTO #3 (JST PH 4x1 PM 90°) connector pinout is the following:

Pin 1 VCC

Pin 2 OSC

Pin 3 VCC

Pin 4 OPTO

5.1.6 STEPPING MOTOR CONNECTOR

The connection of the stepping motor occurs by the means of the connector MOTOR (AMP MODII 4 PM

90°) with the following pinout

Pin 1 OUT 1

Pin 2 OUT 2

Pin 3 OUT 3

Pin 4 OUT 4

5.1.7 SCANNER CONNECTOR

The laser scanner is connected to the CPU board by the means of the connector BCR (JST PH 4x1 PM 90°)

with the following pinout:

Pin 1 VCC

Pin 2 GND

Pin 3 LASER_TRIGGER

Pin 4 TX

5.1.8 CONTACLESS MODULE CONNECTOR

The contactless module is connected to the CPU board by the means of the connector C_LESS (JST PHD

2x5 PM 90°) with the following pinout:

Pin 1 VCC Pin 2 Rx1

Pin 3 Rx1_RS232 Pin 4 Tx1

Pin 5 Tx1_RS232 Pin 6 I/O AUX1B

Pin 7 C_GND Pin 8 C_GND

Pin 9 I/O AUX0B Pin 10 I/O AUX2B

Following drawing and form show the pinout of the connector that must be inserted in the contactless

module.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Keine Kommentare

Adel BCR Bedienungsanleitung Seite 7